Bit:2:Pi BBC Micro:Bit adaptor for Raspberry Pi Addons

No Soldering required - simply screws together

Have a look at the features:

• No separate chassis - everything is connected to the  main circuit board
• 5V switching regulator that can supply a fully loaded Pi as well as all the motors etc. on the Pi2Go
• 2 DC motors
• 3 x IR Obstacle sensors with indicator LEDs – detect objects within 10cm (left side, right side and front)
• 2 x IR line sensors with indicator LEDs - program the Pi2Go to follow lines
• Ultrasonic distance sensor - measure the distance to objects in front
• Push button – non-dedicated switch use in you programs to change mode, switch off, or whatever you want
• 4 pairs of fully controllable RGB LEDS - any colour, any brightness
• 4 light sensors with analog to digital converter built in
• 4 servo outputs controlled by onboard hardware
• Active Power supply monitor: shuts down motors if battery getting low and sends signal to Pi if getting very low

Software:

• A python library module is available with some example programs
• Move motors forwards, backwards, spin left/right or do sweeping turns
• Read the values from all the IR sensors (On or Off)
• Read the distance using the ultrasonic sensor
• Read the value of the switch
• Set the white LEDs on or off (vary brightness)
• [Set the position of each servo - available soon]
• ScratchGPIO version 7 and later fully supports Pi2Go

 Raspberry Pi and Batteries (6x AA) are not included.