The Differential Voltage Probe is designed for exploring the basic principles of electricity. Use this probe to measure voltages in low voltage AC and DC circuits. With a range of ±6.0 V, this system is ideal for use in “battery and...

This Voltage Probe can be used with the Vernier LabPro, LabQuest, LabQuest Mini, Go!Link, Easylink, SensorDAQ and CBL 2 to measure direct voltage. The Voltage Probe is a bipolar sensor. The black lead is grounded along with the...

The Current Probe can be used to measure currents in low-voltage AC and DC circuits or for electrochemistry experiments. The Current Probe measures DC and low-frequency AC currents up to 600 mA. Use Current Probes in combination with...

Use the High Current Sensor in experiments that involve currents larger than 1 A, such as solar panels, hand generators, and other alternative energy projects. The High Current Sensor has a range of ±10 A. Current is measured with a Hall...

Ce capteur possède un cable de 30 mètres de long. Il a été conçu pour des mesures de températures éloignées et à l’extérieur, par exemple, pour mesurer des températures dans des lacs ou des cours d’eau à différentes profondeurs. Gamme de...

Ce capteur de température est formé d’une tige en acier inoxydable qui peut être trempée dans des liquides organiques, des solutions acides ou basiques. Il est formé d’une thermistance et possède une gamme de mesure élargie par rapport...

Ce capteur de température est formé d’une tige en acier inoxydable qui peut être trempée dans des liquides organiques, des solutions acides ou basiques. Il est formé d’une thermistance et peut mesurer des températures de -40°C à 135°C...

Light probe by Texas Instruments The TI Light Probe is a budget light probe for measuring relative brightness. It senses both IR and visible light. The reading reported is a relative number between 0 and 1. Its low cost and ease of use...

The UVA Sensor is an ultraviolet light sensor that responds primarily to UVA radiation (approximately 320 to 390 nm). This sensor is ideal for experiments using UV lamps. UV peak sensitivity: one volt per 3940 mW/m2 at 340 nm Wavelength...

The Vernier Energy Sensor offers an easy way to quantify voltage, current, power, and energy output of small wind turbines and solar panels such as those used in our KidWind Experiment Kits. Setting up a circuit to study renewable energy...

The Vernier Variable Load is used in conjunction with the Vernier Energy Sensor to provide a range of resistive loads for projects such as wind turbines or solar panels. Students can adjust the potentiometer to provide resistances...

The Electrostatics Kit is an accessory for the Vernier Charge Sensor . This kit allows students to perform a range of experiments in electrostatics including the use of Faraday’s pail, quantitative and qualitative measurement of charge,...