Best-seller
Aucun résultat trouvé pour le filtre !
Rotary Motion Motor Kit This kit includes a small electric motor with pulley, rubber band belt, motor clip, and mounting screw. The motor can be attached to the Rotary Motion Sensor, and be used as an analog tachometer, or generator. You can also perform...
Contenu 1 Pièce
CHF 23,00 *
Salinity Standard This 35 ppt standard is used to calibrate the Salinity Sensor. (500 mL)
Contenu 1 Pièce
CHF 25,00 * CHF 39,00 *
Spirometer Durchlaufkopf An extra flow head eliminates the need for equipment downtime while sterilizing your original flow head. The flow head consists of a polycarbonate outer body with a stainless-steel inner mesh.
CHF 118,43 *
Spring Set This accessory kit contains 6 springs that are ideal for physics experiments. The springs are 6 cm long and 0.8 cm in diameter. Three springs have a spring constant of 5 N/m and the other three have a spring constant of 15 N/m.
CHF 37,40 *
Turbidity Cuvette Standard Replacement kit of 100 NTU turbidity standard and one empty glass cuvette.
CHF 78,00 *
Vernier Variable Load The Vernier Variable Load is used in conjunction with the Vernier Energy Sensor to provide a range of resistive loads for projects such as wind turbines or solar panels. Students can adjust the potentiometer to provide resistances...
Contenu 1 Pièce
CHF 141,28 *
Analog Protoboard Connector The adapter fits into a standard prototyping board or National Instruments’ ELVIS prototyping board, providing easy access to the sensor lines. Vernier analog sensors require a 5 volt source and in most cases provide a 0 – 5 volt raw...
Contenu 1 Pièce
CHF 24,00 *
DIN to BTA Adapter This adaptor allows you to connect old DIN style sensors to LabPro, Go!Link, CBL 2, and LabQuest. One end has a female 5-pin DIN connector. The other end is a male BTA connector.
Contenu 1 Pièce
CHF 29,00 *
Digital Protoboard Connector This connector makes it easy to wire the signal from a Vernier digital sensor into a non-Vernier interface. The adapter fits into a standard prototyping board or National Instruments’ ELVIS prototyping board, providing easy access to the...
Contenu 1 Pièce
CHF 24,00 *
Digital Sensor Cable This cable connects Vernier digital sensors to the digital (DIG) port on a Vernier interface. Compatible Sensors and Accessories Motion Detector (included with sensor) Drop Counter (included with sensor) Go!Motion Note: The Digital...
Contenu 1 Pièce
CHF 9,35 *
DIN Sensor to BTA Input Adapter This adaptor allows you to connect old DIN style sensors to LabPro, Go!Link, CBL 2, and LabQuest. One end has a female 5-pin DIN connector. The other end is a male BTA connector.
Contenu 1 Pièce
CHF 10,39 *
Go! Motion to Calculator Cable This 84″ cable is used to connect a Go!Motion or CBR 2 to the I/O port of a TI graphing calculator. The cable has the small I/O plug on both ends. The cable can also be used to connect a graphing calculator to the I/O port on a LabPro,...
Contenu 1 Pièce
CHF 15,58 *