The Current Probe can be used to measure currents in low-voltage AC and DC circuits or for electrochemistry experiments. The Current Probe measures DC and low-frequency AC currents up to 600 mA. Use Current Probes in combination with...

Use the High Current Sensor in experiments that involve currents larger than 1 A, such as solar panels, hand generators, and other alternative energy projects. The High Current Sensor has a range of ±10 A. Current is measured with a Hall...

This probe is designed for outdoor temperature sensing or for measuring temperature at various depths in lakes and streams. It has a 30 m (100 ft) cable. Range: –50˚C to 150˚C Typical Accuracy: ±0.2°C Typical Resolution: 0.07°C User manual

This rugged temperature probe features a wide temperature range, from –20 to 330°C. The high upper limit of the sensor allows for melting point determinations of most organic compounds. Vernier’s wide-range temperature probe uses RTD...

The Stainless Steel Temperature Probe is a rugged, general-purpose temperature sensor that can be used in organic liquids, salt solutions, acids, and bases. Use it as you would use a thermometer for experiments in chemistry, physics,...

Light probe by Texas Instruments The TI Light Probe is a budget light probe for measuring relative brightness. It senses both IR and visible light. The reading reported is a relative number between 0 and 1. Its low cost and ease of use...

The UVA Sensor is an ultraviolet light sensor that responds primarily to UVA radiation (approximately 320 to 390 nm). This sensor is ideal for experiments using UV lamps. UV peak sensitivity: one volt per 3940 mW/m2 at 340 nm Wavelength...

The Vernier Energy Sensor offers an easy way to quantify voltage, current, power, and energy output of small wind turbines and solar panels such as those used in our KidWind Experiment Kits. Setting up a circuit to study renewable energy...

The Vernier Radiation Monitor detects alpha, beta, gamma, and X-ray radiation. Applications include nuclear counting statistics, shielding, and decay rate measurements. The Vernier Radiation Monitor consists of a Geiger-Mueller tube...

The Vernier Variable Load is used in conjunction with the Vernier Energy Sensor to provide a range of resistive loads for projects such as wind turbines or solar panels. Students can adjust the potentiometer to provide resistances...

The Electrostatics Kit is an accessory for the Vernier Charge Sensor . This kit allows students to perform a range of experiments in electrostatics including the use of Faraday’s pail, quantitative and qualitative measurement of charge,...

Use a Power Amplifier to drive a variety of loads, including speakers, lamps, small DC motors, and RLC circuits. The Power Amplifier can produce DC, sine, square, triangle, and sawtooth waveforms. The Power Amplifier allows you to drive...