Top seller
Vernier Disposable Mouthpiece for Spirometer 30... Content 30 Piece (CHF1.14 * / 1 Piece)
CHF34.28 *
No results were found for the filter!
Pressure Sensor Plastic Syringe 20 mL plastic syringe with Luer-Lock connector. Part of the Pressure Sensor Accessories Kit.
CHF3.95 *
Quartz Cuvettes Package of two Starna Cells quartz cuvettes (3.5 mL) and two lids.
Content 1 Piece
CHF595.00 *
Rotary Motion Motor Kit This kit includes a small electric motor with pulley, rubber band belt, motor clip, and mounting screw. The motor can be attached to the Rotary Motion Sensor, and be used as an analog tachometer, or generator. You can also perform...
Content 1 Piece
CHF23.00 *
Salinity Standard This 35 ppt standard is used to calibrate the Salinity Sensor. (500 mL)
Content 1 Piece
CHF25.00 * CHF39.00 *
Spirometer Durchlaufkopf An extra flow head eliminates the need for equipment downtime while sterilizing your original flow head. The flow head consists of a polycarbonate outer body with a stainless-steel inner mesh.
CHF118.43 *
Spring Set This accessory kit contains 6 springs that are ideal for physics experiments. The springs are 6 cm long and 0.8 cm in diameter. Three springs have a spring constant of 5 N/m and the other three have a spring constant of 15 N/m.
CHF37.40 *
Turbidity Cuvette Standard Replacement kit of 100 NTU turbidity standard and one empty glass cuvette.
CHF78.00 *
Vernier Variable Load The Vernier Variable Load is used in conjunction with the Vernier Energy Sensor to provide a range of resistive loads for projects such as wind turbines or solar panels. Students can adjust the potentiometer to provide resistances...
Content 1 Piece
CHF141.28 *
Analog Protoboard Connector The adapter fits into a standard prototyping board or National Instruments’ ELVIS prototyping board, providing easy access to the sensor lines. Vernier analog sensors require a 5 volt source and in most cases provide a 0 – 5 volt raw...
Content 1 Piece
CHF24.00 *
DIN to BTA Adapter This adaptor allows you to connect old DIN style sensors to LabPro, Go!Link, CBL 2, and LabQuest. One end has a female 5-pin DIN connector. The other end is a male BTA connector.
Content 1 Piece
CHF29.00 *
Digital Protoboard Connector This connector makes it easy to wire the signal from a Vernier digital sensor into a non-Vernier interface. The adapter fits into a standard prototyping board or National Instruments’ ELVIS prototyping board, providing easy access to the...
Content 1 Piece
CHF24.00 *
Digital Sensor Cable This cable connects Vernier digital sensors to the digital (DIG) port on a Vernier interface. Compatible Sensors and Accessories Motion Detector (included with sensor) Drop Counter (included with sensor) Go!Motion Note: The Digital...
Content 1 Piece
CHF9.35 *