Top seller
No results were found for the filter!
This adaptor allows you to connect old DIN style sensors to LabPro, Go!Link, CBL 2, and LabQuest. One end has a female 5-pin DIN connector. The other end is a male BTA connector.
Content 1 Piece
CHF10.39 *
This 84″ cable is used to connect a Go!Motion or CBR 2 to the I/O port of a TI graphing calculator. The cable has the small I/O plug on both ends. The cable can also be used to connect a graphing calculator to the I/O port on a LabPro,...
Content 1 Piece
CHF15.58 *
This cable can be used to connect your homemade analog sensors you make to Vernier interfaces. There is a BTA plug on on end and six bare wires on the other end. The cable is approximately 1.5 m long....
Content 1 Piece
CHF10.39 *
This adapter allows you to connect old ULI digital sensors (photogates, radiation monitors, etc.) to LabQuest 2, LabQuest Mini, LabQuest, and LabPro.
Content 1 Piece
CHF28.00 *
This cable can be used to connect your homemade digital sensors to Vernier interfaces. There is a BTD plug on on end and six bare wires on the other end. The cable is approximately a meter long....
Content 1 Piece
CHF10.39 *
This is the standard 1 meter USB cable used for connecting LabPro or a SensorDAQ to a computer. It can also be used to connect any of spectrometers to either a computer or a LabQuest.
Content 1 Piece
CHF10.39 *
Replacement cable for connecting a Vernier Photogate to a Vernier interface.
Content 1 Piece
CHF10.39 *
This rotary motion adapter allows a Rotary Motion sensor to be connected to the BTD port of LabPro or CBL 2.
Content 1 Piece
CHF10.39 *
The Low ISE standard is used to calibrate our Ammonium Ion-Selective Electrode. This solution has a concentration of 100 mg/L.
Content 1 Piece
CHF68.00 *
The Low ISE standard is used to calibrate our Ammonium Ion-Selective Electrode. This solution has a concentration of 1 mg/L.
Content 1 Piece
CHF36.36 *
This module replaces the electrode membrane. Simply unscrew the old one and screw on the new one. The membrane of an Ammonium ISE electrode has a limited life span of one to two years, regardless of frequency of use. Do not order it...
Content 1 Piece
CHF161.23 *
The High ISE standard is used to calibrate our Calcium Ion-Selective Electrode. This solution has a concentration of 1000 mg/L.
Content 1 Piece
CHF41.55 *