Topseller
Für die Filterung wurden keine Ergebnisse gefunden!
Quartz Cuvettes
Package of two Starna Cells quartz cuvettes (3.5 mL) and two lids.
Inhalt 1 Stück
CHF 595.00 *
Rotary Motion Motor Kit
This kit includes a small electric motor with pulley, rubber band belt, motor clip, and mounting screw. The motor can be attached to the Rotary Motion Sensor, and be used as an analog tachometer, or generator. You can also perform...
Inhalt 1 Stück
CHF 23.89 *
Salinity Standard
This 35 ppt standard is used to calibrate the Salinity Sensor. (500 mL)
Inhalt 1 Stück
CHF 25.00 * CHF 39.00 *
Spirometer Durchlaufkopf
An extra flow head eliminates the need for equipment downtime while sterilizing your original flow head. The flow head consists of a polycarbonate outer body with a stainless-steel inner mesh.
CHF 118.43 *
Spring Set
This accessory kit contains 6 springs that are ideal for physics experiments. The springs are 6 cm long and 0.8 cm in diameter. Three springs have a spring constant of 5 N/m and the other three have a spring constant of 15 N/m.
CHF 37.40 *
Turbidity Cuvette Standard
Replacement kit of 100 NTU turbidity standard and one empty glass cuvette.
CHF 78.00 *
Vernier Variable Load
The Vernier Variable Load is used in conjunction with the Vernier Energy Sensor to provide a range of resistive loads for projects such as wind turbines or solar panels. Students can adjust the potentiometer to provide resistances...
Inhalt 1 Stück
CHF 141.28 *
Analog Protoboard Connector
The adapter fits into a standard prototyping board or National Instruments’ ELVIS prototyping board, providing easy access to the sensor lines. Vernier analog sensors require a 5 volt source and in most cases provide a 0 – 5 volt raw...
Inhalt 1 Stück
CHF 24.00 *
Adapter DIN auf BTA Eingang
Die älteren Sensoren haben den runden 5poligen DIN-Stecker, während die neuen Sensoren den BTA-Stecker (British Telecom) verwenden. Die älteren Sensoren können jedoch mit dem DIN-auf-BTA-Adapter am LapQuest Mini, LabPro, Go!Link, oder...
Inhalt 1 Stück
CHF 29.00 *
Digital Protoboard Connector
This connector makes it easy to wire the signal from a Vernier digital sensor into a non-Vernier interface. The adapter fits into a standard prototyping board or National Instruments’ ELVIS prototyping board, providing easy access to the...
Inhalt 1 Stück
CHF 24.00 *
Digital Sensor Cable
Ersatzkabel für den Anschluss des MD-BTD oder des GO!-Motion an einen Digitalport eines LabQuest, LabCradle, LabPro oder CBL.
Inhalt 1 Stück
CHF 9.35 *
DIN Sensor to BTA Input Adapter
This adaptor allows you to connect old DIN style sensors to LabPro, Go!Link, CBL 2, and LabQuest. One end has a female 5-pin DIN connector. The other end is a male BTA connector.
Inhalt 1 Stück
CHF 10.39 *